This strip, called the radar swath, runs parallel to, and to one side of, the satellite's ground track. ESA's first generation of Earth Observation satellites, ERS-1 and ERS-2 launched in 1991 and 1994 respectively, fly at a mean altitude of 785 km, and have a look angle of 23 degrees from local vertical, and a 100 km swath width. In contrast to images taken by classical visible and infrared 'camera like' sensors, images collected by a SAR are severely unfocused when in their raw form and are unusable without additional data processing. In fact, considerable processing is required to generate a focused image with high spatial resolution (See the Development of a SAR processor section). In the case of ERS-1, resolutions in the order of 5 metres along track (parallel to the flight direction) and 8 meters in slant-range (perpendicular to the flight direction) are achieved. After slant to ground range projection, the ERS-1 ground range resolution is approximately 20 meters. Improved imaging capabilities are provided by the Advanced SAR (ASAR) flown on the Envisat-1 Polar Platform. ASAR has an electronically steerable antenna for acquiring image data with selectable look angles and swath positions. In particular, the so called "wide swath" new mode of ASAR can collect image data over a 400 km. swath by periodically changing the look angle so that the radar beam is switched between five adjoining sub-swaths. This sort of scanning is called ScanSAR, and has the advantage of providing a much larger coverage at the expense of degrading the spatial and radiometric resolution of the final image (See images). ScanSAR techniques are also used in the American SIR-C and the Canadian RADARSAT missions. For all the missions and modes described above, the echoes are digitised On-Board and immediately sent to ground for processing. We provide here below the key parameters of the popular ERS-1 satellite. For a better comprehension, compare this to the geometry figure of a SAR system.