Spacecraft facts | |
Spacecraft bus dimensions | 1.5 x 1.8 x 1.4 m |
Spacecraft mass | 1270 kg (including 93 kg of payload and 570 kg fuel) |
Thrust of main engine | 400 N |
Attitude thrusters | Two sets of four, each delivering 10 Newtons each |
Solar arrays | Two triple-junction Ga As; 5.7 square metres; generating 800 Watts near Earth and 1100 Watts at Venus |
Power storage | Three lithium-ion batteries |
Antennas | Two high-gain dishes, HGA1 = 1.3 m diameter, HGA2 = 0.3 m in diameter, 2 low-gain antennas |
Meedia modaal
As with Mars Express, the scientific instruments were mounted in the bus. Only minor changes from Mars Express were required to accommodate the revised instruments payload, which was concentrated on three sides of the spacecraft.
However, the environment of Venus is very different from that of Mars. This required some design changes that made Venus Express more suited to operating around Venus.
To keep Venus Express within temperatures that were safe for the spacecraft, the radiators on the spacecraft surface were increased in area and efficiency. The spacecraft coating, called ‘multi-layer insulation’ or MLI, was composed of 23 layers, packaged differently from Mars Express.
Moreover, for Venus Express, the MLI was gold instead of black, which provided greater capability to reflect radiation away. In general, Mars Express was designed to keep warm while Venus Express was modified to stay cool.
Meedia modaal
The two symmetric solar arrays, measuring around six square metres, were based on a ‘triple junction’ gallium arsenide (GaAs) technology, different from the silicon-based technology used for Mars Express.
The solar cells, each composed of four layers of gallium arsenide, were more tolerant to high temperatures (up to around 120 °C), so they were more suitable for hot environments. Moreover, they were able to exploit a wider range of solar radiation. The solar cells were separated by aluminium strips that helped to reject heat. All together, these aluminium strips covered half of the overall solar array surface.
When the spacecraft was in shadow (eclipse) or when its power demand exceeded the capacity of the solar arrays, electrical power was supplied by three lithium-ion batteries that were charged by the solar-generated power.
This energy was provided by part of the 570 kilograms of propellant on board (about 20% more than for Mars Express). The propellant mass was almost half of the overall spacecraft weight!
Major spacecraft manoeuvres, like the injection into orbit around Venus, were performed by firing the main engine located at the bottom floor of the spacecraft, while minor manoeuvres were made using four pairs of thrusters located at the four bottom corners of the spacecraft.
The thrusters were used for small trajectory corrections, spacecraft attitude changes, and to correct the altitude of the Venus Express orbit’s pericentre about every 50 days. In fact, due to the gravitational pull of the Sun while the spacecraft is farther away from the planet, the pericentre naturally drifted upwards at a rate of about 1.5 kilometres per day.
To overcome this pointing constraint, Venus Express had two high-gain antennas, mounted on different spacecraft faces. The main high-gain antenna, used for most of the communication with Earth, was a dish measuring 1.3 metres diameter.
The second and smaller high-gain antenna (30 centimetres diameter) was used to communicate with Earth when the spacecraft was in the part of the orbit closest to our planet (less than 0.78 Astronomical Units* away).
Two low-gain antennas were also mounted on board, to communicate with Earth during launch, in the first days of the cruise and, if necessary, during severe ‘safe modes’.
*One Astronomical Unit, defined as the mean distance between the Sun and Earth, is about 150 million kilometres.
These on-board systems consisted of two star trackers, two Sun sensors and a set composed by three laser gyroscopes and three accelerometers. They provided data to re-orient the spacecraft and the solar arrays when necessary.
The actual spacecraft re-orientation manoeuvre or trajectory correction was performed by means of so-called ‘reaction wheels’ or by firing the thrusters.
Part of the computer was the Solid State Mass Memory, which had a capacity of 12 gigabits. All scientific data collected by the instruments were stored here until they could be downloaded to Earth during the appropriate orbital phase.
Meedia modaal
Venus Express overview
Venus Express science highlights
Venus Express operations
püsige kursis
Telli meie uudiskiri, et saada uusimad uudised, missioonide värskendused ja eksklusiivsed ülevaated otse oma postkasti. Ole esimeste seas, kes saab teada meie tulevastest projektidest ja läbimurretest.